Order JWH-018 Liquid and Spray from Liget fenta meds
JWH-018 Liquid And Spray is a synthetic cannabinoid found in several versions of the herbal mixture “Spice.” While considerably more potent than similar amounts of cannabis, JWH-018 also presents significant challenges for detection by typical Δ9-THC testing assays.
Full chemical name: Naphthalen-1-yl-(1-pentylindol-3-yl)methanone
Other names: JWH-018
CAS number of substance: 209414-07-3
Physical properties: Small powder
Molar mass of the substance: 341,45 g/mol
Purity of the preparation: 98% and above
At Atlas Farma, we have JWH-018 available as
- JWH-018 Powder
- JWH-018 Liquid
JWH-018 Powder and Liquid
and your choice of JWH-018, JWH-073, JWH-200, JWH-250 or any other JWH
Okay let’s get started.to purchase this product check here
Measure out 5 milliliters of Acetone and pour it into a small mixing bowl, then weigh out 1 gram of quality JWH-018 and pour it carefully into the mixing bowl. Next you will mix JWH and Acetone together until JWH is complete liquid. If needed slowly add more acetone to fully mix JWH. More Acetone will not effect the potency of your incense but it will effect it’s drying time and possible the Aroma. Finish mixing the Acetone and JWH together. Carefully pour Acetone-JWH mixture into spray bottle. Adjust the spray bottle to the finest mist possible because a finer mist will give a better balance to your incense. Using 5 ml of Acetone will work but it might be difficult if the spray bottle is to large. If spraying becomes difficult then slowly add acetone until spraying becomes
JWH-018 spray and Liquid
Weigh out exactly 2 ounces of Foliage leaves. Remember the amount of foliage leaves used is the main factor in how potent your incense is going to be. Using 1 Gram of JWH with 2 ounces of foliage leaves is a little under 20 mg which is strong. It’s very similar to k2 summit. If you want a less potent blend add more foliage but I would not recommend adding more JWH! Pour foliage into baking dish and spread it around evenly then begin to spray the tops of the foliage with your JWH mixture. It is very important to spray as evenly as possible! You do not want to get any hotspots.
JWH-018 Liquid and Spray
Hotspots are when there is to much JWH on one piece of foliage. After spraying the tops of the foliage use your gloves and mix the foliage around and re spread foliage out over the entire baking dish again. Again spray the JWH mixture evenly through out the dish. Continue this process until all the JWH mixture is gone.
Let the incense dry over night for best results. JWH incense tends to clump when it drys. Simply break up clumps and mix well. Add your flavor extracts and drops only after incense has dried.
You have now made 2 ounces of high quality incense! Have fun and as always be safe!
Where to buy JWH-018 Liquid and spray
Opioids.to online store is the only place you can order JWH-018 Powder and Liquid at your own safety because we are a license online store .